Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have recently installed a PIX 515e replacing a 506e. The reason we did this was to set Citrix Web and Gateway servers inside a DMZ. The pix has three interfaces outside, inside and DMZ. I need to be able to allow the DMZ servers to access a Citrix...
It is possible to set up RAS on 2003 and use a public ip address to statically translate your vpn connection. I believe you can use a conduit with your version. If not use an access list instead. Step 1. Configure your pix with nat (inside) 0 access-...
The last post was correct. I had an access list without a group so, I fixed that. All is well. However, I have two static translations for the servers in the DMZ that are translated to public ip addresses. Shouldn't I be able to go the public ip and ...
