Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to configure traffic load sharing & router backup on following scenario :On the ethernet LAN, multiple IP hosts connected to a Cat2950.The Cat2950 is connected to two routers 831.The routers 831 give an access to the Internet netwo...
Hello,Just to check if I understood well. If we had configured a trunk access between the switches, the frame would be tagged and PC1/PC2 would not be able to ping each other ?
Hello,I think there is an error of config on giga-eth interface, I think it should be :interface gig0/1 switchport trunk allowed vlan 2,10 switchport mode trunk no ip addressBut anyway, as PC1 and PC2 belong to two differents VLANs, they will not be ...
