Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a 3005. I am using Cisco VPN Client 4.0.1 on XP. I am able to connect to the concentrator. I have enabled split tunnel. I can go any where in the internet. But when I am trying to to other servers with the network I can not. If I ping th...
Hello,We have a VPN Concentrator 3005. We want to monitor the bandwidth of the Lan-to-Lan IPSec connection using MRTG. Can somebody help me in getting me the correct OID?TISSaswata
Hello, We have a dedicated line going to our client's datacenter. We have a dedicated telephone connected to the modem which is connected to the auxiliary port of the router. Their security policy says that the telephone line should disconnect after ...
Hello,We have a dedicated line going to our client's datacenter. We have a dedicated telephone connected to the modem which is connected to the auxiliary port of the router. Their security policy says that the telephone line should disconnect after i...
Here is the situation:I have a user A use AT&T as the dialup provider. Connects to our 3005. Gets an IP address 192.168.1.2 and works perfectly fine. After few minutes he/she disconnects from our 3005 & AT&T.Another user B use SPRINT as dialup provid...
Georg,The modem is a US Robotic V90 external modem. How can I configure the modem which is at a remote location?Please help me.Regards and thanksSaswata
No this one did not work.Here is my setup for Async 5.interface Async5 ip unnumbered FastEthernet0 encapsulation ppp dialer in-band async mode interactive peer default ip address pool ris pulse-time 3 ppp authentication chapThe command dialer idle-ti...
