Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of our 2802 APs does not boot correctly. Connecting to the console after powering on, a preboot hw selection menu is displayed. After typing the correct number (2) the AP boots up. How can I disable the menu? Output:BootROM - 1.78Booting from SPI...
I don't know why but I also can't use progpid.My masterboot version is 1.34. this is different to the other ap's 1.24.All commands I find in u-boot with p are:u-boot>> ppci pciePhyRead pciePhyWrite phyRead phyWrite phy_fw_down_to_ramphy_fw_down_to_sp...
Sorry there is no prish command in u-boot. Maybe printenv is similar? u-boot>> printenvBOOT=part1CASset=maxENABLE_BREAK=1FACTORY_RESET=2MALLOC_len=5MANUAL_BOOT=0MEMORY_DEBUG=0MPmode=SMPautoload=yesbaudrate=9600bootcmd=nandbootbootdelay=3cacheShare=no...
