About JamesRobertson

JamesRobertson · 09-08-2020

Hello everyone, Here is the scenario. I have a HDMI TX and Multiple HDMI RX receivers. These devices can be configured to use UDP packets from the TX box to multiple RX receivers on the same Vlan displaying the same image for my guests. However I ...

JamesRobertson · 08-25-2020

Hi everyone. So I have several Cisco WS-3850-48x-x series switches that are running Stackwise-Virtual. Recently I found that these series switches are not supported by IOS 16.12.3a and since 16.6.x and 16.9.x are going into EOL I am guessing that t...

JamesRobertson · 09-10-2020

Well found the problem. These HDMI Extenders were definitely cheep. All RX devices use the same MAC Address and so does the TX devices. Thank goodness they actually were programmable at the interface as that cleared up all my issues.

JamesRobertson · 09-10-2020

Yes I have tried a cold boot as well.

JamesRobertson · 09-09-2020

Thank you for the responses. Sorry for not posting the hardware Cisco Catalyst 3850 WS-C3850-48P sw:16.12.3a stack config.End devices are NTI ST-IPHD-LC, TX and RX HDMI Extenders.Port 33 is the Transmitter end devicePorts 34,35,36 are the receiver en...

JamesRobertson · 08-25-2020

I receive the error when running Cisco CLI Analyzer. "WS-C3850-48F is running non suggested IOS-XE version 16.12.3a." Also the document here Recommended Releases for Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms states on the b...

Member Since	‎10-16-2017 08:21 AM
Date Last Visited	‎06-16-2021 12:04 AM
Posts	6

User Statistics

User Activity

VLAN XXX is flapping between port Gx/x/x

Cisco WS-3850-48F-E with Stackwise-Virtual IOS

Re: VLAN XXX is flapping between port Gx/x/x

Re: VLAN XXX is flapping between port Gx/x/x

Re: VLAN XXX is flapping between port Gx/x/x

Re: Cisco WS-3850-48F-E with Stackwise-Virtual IOS