Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon,I'm having an issue that I hope the community can help me with.We have a corporate LAN (192.168.0.0/24), and a secondary LAN (192.168.2.0/24) at a remote site. At the remote site, we also have an internal network of servo-controllers w...
Quite the contrary, all of this is new to me. I've worked with firewalling and VPN, but this is uncharted territory... call it on-the-job training, literally. Thanks for your input, and I will report back with my success, or lack thereof.
We were planning to use a "router on a stick" configuration, something like...interface FastEthernet0/0 description PLANT_INSIDE ip address 192.168.2.254 255.255.255.0 duplex auto speed auto!interface FastEthernet0/0.10 encapsulation dot1Q 10 ip addr...
Allow me to clarify the topology now that I've had some time to dig into it. The 10.10.0.0/16 subnet faces our infrastructure without any sort of gateway. The devices come into our LAN via fiber, which goes into a Dell 2824, which then goes into a WI...
I cannot confirm that the other site is using EIGRP, but the other sites (2.x, 101.x) do. Right now, the only address I can successfully ping from the 10.10.0.0/16 is 10.10.0.254.EDIT: I can confirm after further investigation that the other site is ...
The 10.10.0.0/16 subnet is managed by a third party so I'm not sure how their infrastructure is set up, but I know the equipment terminates into a fiber run that comes back to our server room, into a fiber mod, which goes into a Dell 2824 switch, whi...
