Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a site-to-site VPN tunnel setup between two RV320's, GW to GW. The tunnel is created and stays up, but I can't ping any of the hosts on the other end. It's not a FW or ACL issue since I disabled it and tried pinging the distant end, but noth...
Samir,I cannot ping 192.168.1.1 or 192.168.2.1 from either side of the tunnel and vice versa.This is the routing table on the RV320 at SiteA. I thought for traffic to traverse the tunnel, the default route for 192.168.2.0/24 (SiteB) would be XXX.XXX...
Samir,Thanks for the response! I figured out that the 172.16.X.X is only used when you go client to VPN.Both side of the tunnel are using subnets 192.168.1.0/24 and 192.168.2.0/24 respectively. I know the issue is routing, and once the tunnel comes...
