Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All Network Topology Internet > RV325 > SG200-18 4 VLANs setup4 WAP371 APs All devices connected via the SG200-18 switchAll Network devices running ALL the Vlans. RV325 - Routing on Stick setup - no inter-vlan routing.SG200-18 = RSTP Root BrigdeI...
Hi all, hope someone can assist. Would like to route non-local traffic (Internet Traffic) from a single local host (192.168.20.7) through the VPN tunnel setup between two networks. (Router A - 192.168.10.X) > IPSEC VPN > (Router B - (Cisco 860) - 192...
Yes, the VPN tunnel is up and working.Yes, i'd like the outbound traffic (to port 8080) from Router B to flow through the tunnel to Router A - (RV325) and NOT directly via the WAN interface on Router B (Cisco 800).I have the following in the ACL on t...
Did you get this resolved, if so how? I am seeing exactly the same issue, VPN seems up via the admin interface however can't seem to ping the default gateway at either side of the tunnel.
