About samiyengar

samiyengar · 11-25-2002

I have configured the 1710 as firewall. Have a Cable to Internet and POP3 Incoming E-mail and SMTP outgoing. When I open up my Outlook and click on Send/Receive gives the Server could not be found. Would like to know the config to allow 110 (POP3)...

samiyengar · 11-28-2002

Found the problem. It was the FQDN for POP3 & SMTP which was the issue.The ISP had changed it for the dynamic IP which I get for my router. I entered the right FQDN works ok.Thanks for the help. It was fun anyways.

samiyengar · 11-28-2002

I did a clear ip nat trans * and than sh ip nat trans. I don't see any entry except for this.Pro Inside global Inside local Outside local Outside globaltcp 24.13.62.254:110 10.1.1.2:110 --- ---This is because I add...

samiyengar · 11-27-2002

Hi I did try with the PC outside this router and it works.

samiyengar · 11-27-2002

My NAT(PAT) config is as follows:ip nat inside source route-map nonat interface Ethernet0 overloadaccess-list 130 permit ip 10.1.1.0 0.0.0.255 anyroute-map nonat permit 10 match ip address 130With only NAT(PAT) and no ip access-group 120 & 140 in on ...

samiyengar · 11-27-2002

sh log gives the following: I don't know what is that 10.45.128.1 address. Thisdenied session logs even without clicking send/receive in Outlook. Looks likenothing gets logged with my Outlook doing send/receive. I just get the errorserver could n...

Member Since	‎06-21-2001 04:08 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	8

User Statistics

User Activity

1710 configured as Firewall

Re: 1710 configured as Firewall

Re: 1710 configured as Firewall

Re: 1710 configured as Firewall

Re: 1710 configured as Firewall

Re: 1710 configured as Firewall