Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OK Cisco peeps, here's a weird one for your consideration.
I have this network with a Catalyst 2960XR stack as the switching core. I have Aerohive APs and lots of wireless clients. I have lots of VLANs. 100 for infrastructure and 102 for WiFi guests...
Community, this is probably an easy one for someone out there who knows what he's doing.Setup:============I have an ASA5510 with 4 interfaces: outside 1.2.3.107 (sec level 0) inside 10.0.0.251 (sec level 100) guest 172.31.255.0 (sec level...
Hi SH,
I _think_ the stack is running IP-Lite licensing. That rings a bell from when I was buying these switches. Yes, I have DG interfaces defined on the stack for all the VLANs.
IOS = Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Vers...
Hi Dennis. Yes, the MAC of the problem WiFi clients seem to register correctly in the ARP table of the Catalyst as soon as they acquire a DHCP lease, so that looks nominal at first glance. Nonetheless, I've tried clearing the dynamic entries using 'c...
All,I have this new stack of Catalyst 2960XR switches, two of which have the two SFP+ ports on the far right hand side that I'm trying to use as 10GB ports for storage networking. However, it's not clear to me (even after reading through reams of Cis...
OK, in case anyone is interested in this thread still, here's the line that turned out to be the crux move:==============start config quotestatic (dmz,guest) 10.0.255.10 10.0.255.10 netmask 255.255.255.255==============end config quotewhich provides ...
Again, thanks Matt for your replies. Very specific, useful and relevant.I've implemented that static translation statement and it appears to have cleared up the previous error about portmap translation creation, but now I'm getting a different error,...
