Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please refernece below the text of a case currently open with TAC. It describes the situation we're experiencing:Problem Description: TCP Connection appears to hang. Entry in SHO CONN shows aging at 2+hrs, no activity. Source port 1026 dest port 1478...
I have two Cisco routers on LAN interface with outside segment of PIX525, both terminating T1 connections to same client site. Want to be able to load balance between the two. One is on 192.168.124.110 and the other on 192.168.124.111, firewall outsi...
I'd rather not post the config for 'obvious' reasons. There is no router 'between' the gateway(s) and the PIX inside interface. However, the MS SNA gateways default gateway to a VLAN interface on MSFC in 6509. ICMP redirects occur from the switch whi...
I'm running 900+ on PIX525 with no problems at all (other than managing the cotton pickin things ;-0 ).Cpu is nothing 2-5% tops with approximtely 2000+ connections.
No you cannot configure TCP timeout by port number but TCP timeout value is configurable.TIMEOUT CONN hh:mm:ss (minimum 5 minutes). I believe default is one hour.We've been asking the question as well due to an application problem using Microsoft SNA...
