Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are looking for a solution in our environment that would perform intrusion prevention, threat defense, advanced malware protection and content filtering. I know fire power and AMP can do all that, but I need help on understanding how all these can...
I am trying to configure a 3850 switch to be able to route to destinations 192.168.XXX.21 and 192.168.YYY.21 via two routers. I have sub-interface between the router and the switch for connectivity. RT1 is 10.20.XX.1 and RT2 is 10.20.YY.1. The proble...
I had the same issue and all I had to do was enable spanning tree portfast on the ports where my clients were connected, apparently the clients were not waiting long enough (ports to complete its cycle of listening, learning, forwarding) to get an IP...
The routers are connected to port 1/0/22 and 2/0/22.
!version 16.6no service padservice timestamps debug datetime localtimeservice timestamps log datetime localtimeservice password-encryptionservice compress-configno platform punt-keepalive disable...
I don't think this is going to be of any help.
SW#ping 192.168.228.21Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.228.21, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 10/10/11 msSW...
SW#sh ip route 192.168.228.21Routing entry for 192.168.228.0/24 Known via "static", distance 1, metric 0 Routing Descriptor Blocks: 10.20.32.1 Route metric is 0, traffic share count is 1 * 10.20.30.1 Route metric is 0, traffic share count is 1
SW#sh ...
