Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running 12.0(5)WC5 on a 3548XL, but I can find no way to make the switch accept an SNMPv3 user.The commands I'm entering are as follows: snmp-server view iso included snmp-server group v3group v3 noauth read all write all snmp-server user v3us...
You can 'disable' STP on a port-by-port basis by enable spanning-tree portfast.I've never had STP running on any server-facing port and I've run Fast EtherChannel on Intel NICs fine.
I'm doing similar - I just specify "logging 192.168.200.153", "logging trap informational", "logging source-interface loopback0" and "logging on" and it works like a dream.Since syslog runs over UDP, you'll probably lose any messages such as VPN tunn...
Do you have anything doing stateful inspection somewhere along the line? This would cause the ICMP echo-request packets to get through fine but the already established FTP session to be terminated.
What I did for my SOHO91 at home is to buy the lowest level of SmartNet that entitled me to software upgrades. In the end, I just went for 8x5xNBD as its really quite cheap for a SOHO.I'm also using non-Cisco memory (cleaning out your office unearth...
I looked at the URL yesterday, and unfortunately it wasn't much help in this case.The problem appears to be with getting the switch to accept the "snmp-server user..." command. I'm convinced I'm doing something wrong here!
