Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've recently purchased a couple of accespro cards and noticed that theyhave an interface listed as pcbus0. I was unable to find any reference to it in the online documentation. It appears that they are configurable interfacesso I'm curious as to wha...
I have an accespro router which I can't get the line protocol on E0to change state to up on E0.I just purchased this card on Ebay and I have 2 other like cards.I did a wr erase on the card, reloaded the router, bypassed auto-install,and manually conf...
I installed 2 8 meg flash simms in a 2501 which now leaves me at the(boot)> prompt. When I do a sh flash I see 2 partitions. From globalconfig mode I have used the "no partition flash command" and get a response of " %error default partitioning...
What is the difference between btwn these 2 types of promptsR1> R1(boot)> I had a dead 2501 with 16meg of flash in it and swapped it out to another2501 that only had 8meg. I put both of the flash simms from the dead2501 into the workong one. After I ...
When I type enable ( Enter ) from user mode to try and enter privileged modeon an acesspro card I get this response ( % No password set ) and I'm returned to user mode. Any suggestions. I just picked up this card offof ebay so I'm not sure whats been...
Prob. is solved. Cockpit error by me. I was trying to console in via the aux portwhich is one of the rj45 ports on the card. I now know you have to set up a terminal session via com 2 ( the default by way of the jumper settings on thecard ) thru the...
Problem is solved. It was necessary to do an " erase flash " and you are then prompted for which partition with the default being 2, which in my case waswhat I wanted to do. So I excepted the default. Then I went to glob. config.mode and entered "...
