Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Well the title probably didn't make much since, but I'm looking for help understanding the following method of configuring a PIX that I recently ran across....%75 of LAN systems do not use restricted subnets as defined by rfc1918 (10.x.x.x, etc.), re...
Quick question...Reviewing a network configuration in which a Cat5500 w/rsm is in the core of the main site (roughly 150 remote sites, most over FR links). It's working fine, some issues but outside the scope, and configured properly IMO. My questi...
Changing the Internal int IP on a PIX 515 ver 6.2 from x.x.x.1 to 192.168.1.1 to coincide with the lan... what issues should I be prepared for? Can I export the config through tftp/PDM v2, make all mods, and import?Could I be so lucky to change the ...
Thanks for the info Leo, it was all very helpful. I'll respond, and please let me know if the additional info changes the situation at all.1. My level of understanding of the static command:I have a good grasp on it, but am no expert; have a couple ...
Inet-router-->PIX-->LAN%90 of all hosts within first two hops of the PIX's Inside interface are using real world IP's (not compliant with rfc1918). Roughly 40 Srvrs, 300 users, and if RAS is counted (RAS users also recieve real world IP upon dial-in...
Sounds familiar.....We are about 20% down the road in rolling out 103 remote site 1760's over Frame, terminating in a 3600 at the core (via demuxed DS3).Recently tackeled the addition of a lab setup in the same office as the 3600 and wanted to spoof ...
