Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running ISE 2.3 with 2 nodes in Active / Standby.I have 4 Cisco 8851 IP phones.My Authentication policy is Wired 802.1X and Network Access EAPAuthentication equals EAP-TLSMy Authorization policy is Network Access EAPAuthentication equals EAP-TLS and ...
We are preparing to deploy Cisco UC and IP phones throughout our environment. I have read many articles on preparing ISE for the use of Cisco phones (CAPF cert from UC imported to ISE, new CAP profile etc). The issue that I am running in to is we a...
Scratch my previous post as I must have fat fingered something. There is a difference but I can't tell why one phone works and one doesn't. All 4 of my test phones are plugged into the same switch so I am pretty sure it isn't the switch config. Be...
That's the odd thing about it. We don't have what I would consider a complicated ISE setup. In looking at Context Visibility everything is the same for a phone that works and a phone that doesn't work. See below. Thanks for the help.
