Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I had some problem with a WAN connection.On the main building we had 2 cisco 26xx with 1eth 2serial each for a total of 4 dedicated line. Main building connect 2 remote building (A and B) with 2 line each for business continuity purpose. On buildi...
Hi.My 2 PIX 515E firewall configured on failover mode, protect 2 server form outside connection.Can i load balance or load share with pix the load on the two servers?Can i configure PIX like ios routers to balance per session, so the clients randomly...
Someone can write me down some links to find documentation onhow redirect cisco routers and pix firewalls log to a WINDOWS 2000 EVENT LOG or a UNIX/WINDOWS SYSLOG?Many Thanks.G.
Hi.I need to connect 2 adsl router 827 togheter.My provider sold me a leased adsl line point-to-point (pvc 8/35)On each router the line is good (CD correctly detected), but i have someproblem to configure the connection.The configuration about interf...
Ok, then my clients should see the original pix ip address, not the failover ip ..Failover ip aro only used to setup comunication with the 2nd pix that act asa standbyIs this correct? Yes, i follow exaclty the instruction on the manual pages.Can i us...
I have already setted ip route cache on that interface.Perhaps it was present a no ip redirect parameter on eth interface.This can cause the loss of packets?
