Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 4006 switch which had 3 Vlan's configured. There is a cisco 3640 router routing between the three vlans. The supervisor failed on the 4006 and was replaced. I recreated the vlan's( vlan1,2 and 3). When I assign a port to a vlan other ...
I'm trying to get my Pix 501 to get a address from my service provider. I am connecting to the internet via cable modem. The Pix fails to get an IP address. I did a debug and it seems the service provider is sending DHCP option 82. What do I have to...
Vlan 1 can get to the router and beyond. There is no encapsulation statements on the router. Others can ping any device on Vlan1. What's hapenning is everyone is now on Vlan 1 and all DHCP addresses that were assigned for vlan 1 is being used up.
