Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco ir1101, i cannot ping mpls ipv4 neighbor loopback address through tunnel, it is carrier circuit and have mtu size 1500.my question is mpls will working on circuit have mtu 1500? because i am planning to run MP BGP and have OSPF between tunnel a...
Hello everyone.xconnect encapsulation mpls not coming up between two ASR920. i am not sure if i am missing any configuration. kindly assistASR920-01interface GigabitEthernet0/0/9mtu 1518no ip addressnegotiation autono keepaliveservice instance 1 ethe...
Hello Everyone,i am not sure, if i am missing something but below configuration is that we have two links to different OSPF area 17 and 55 and this router is not ABR, what we are trying to do that if link goes down to area 17, i want loopback address...
We have unknown protocol and output drops to Meraki, cdp is enabled but not lldp. Does any have face this kind of issue?GigabitEthernet0/0/x is up, line protocol is upHardware is 24xGE-4x10GE-FIXED, address is 706d.155c.af9x (bia 706d.155c.af9x)Descr...
Yes i can ping it and also LDP is up too.ping mpls ipv4 192.168.1.2/32 source 192.168.1.1Sending 5, 72-byte MPLS Echos to 192.168.1.2/32,timeout is 2 seconds, send interval is 0 msec:Codes: '!' - success, 'Q' - request not sent, '.' - timeout,'L' - l...
i dont have access to other end.also i dont have QoS configured. below is my port config.interface GigabitEthernet0/0/12description xip vrf forwarding xxip address x.x.x.x 255.255.255.252no ip redirectsno ip unreachablesno ip proxy-arpnegotiation aut...
