Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,The tunnel connects and I am able to grab an IP address from the correct range. However, I am not able to pass traffic between the tunnel (192.168.5.0) and the DMZ interface/network (192.168.4.0).What piece or pieces am I missing from my configur...
Hi,PIX 515e, upgraded from 6.3(5) to 7.2(3)Upon rebooting ACL's do not work to allow SMTP, RDP, etc.Not sure if I am missing a command, etc. Please see config below:PIX Version 7.2(3)!hostname PIXdomain-name Something.comenable password xxxnamesdns-...
What issues arise if I have a router which plugs in to a switch (2950) and I have two separate PIXs attached to the same switch? I have a block of Public IP's (6 usable), 5 would go to PIX1 and 1 will go to PIX2. Am I looking at a routing nightmare...
I need to turn off DNS Gaurd to test a theory about reverse lookups not succeeding by outside mail servers. It has been brought to my attention by users that certain mail servers from other companies will perform a Reverse Lookup on the address send...
I am consulting with a company that has 15 remote sites connected to the main office. The main office is running frame-relay through one interface that is sub-interfaced into 15 sub-interfaces to serve the 15 offices. All the interfaces are on an ...
The switch will build the MAC tables indicating where each PIX device is located (on each respective port) for each PIX attached to the switch. The route statements from the router simply "route" the packets destined for the that network out the des...
We have a business partner that we want to remove from one side of the network and want to put them on their own PIX. No VLANs, PIX1 is company side, PIX2 would be business partner side. If both PIXs are connected to the switch (residing before the...
You are correct in performing your NSLookups and you are correct regarding the domain name, cgtcollege.orgI will contact Rcom by phone tomorrow as I have logged in to my account for Rcom and there does not appear to be an option to work or set Revers...
