Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I'm looking for a method to match packets on their specific length and either deny or allow them out of the interface. I know router IOS supports it via policies and 'match packet lenght' command. So far I wasn't able to find anything of thi...
Hi guys, Please take a look at the design at:http://home.comcast.net/~vtaranov/topology.jpgG5484: 1000BaseSX GBICG5483: 1000BaseT GBIC1000T: fixed uplink 10/100/1000T portsI know it's not the best design (trying to facilitate existing one) but I n...
Hi there,I did the search but wasn't able to identify whether Catalyst 3550-12G IOS Enhanced Multilayer SW Image supports DLSW or DLSW+ feature...Does anyone know if DLSW can be performed to route non-routable 802.2 DLC protocol over TCP/IP network o...
I wish you guys would allow to pair Vlan not only with another Vlan but also with L3 GigE, Fe or ATM interfaces, as usually the 'outside' interface of the switch is just that...
Pix won't do proxy ping, i.e. respond on behalf. To resolve your 3rd point you'd need to set up a static NAT without specifying tcp 25, i.e.:static (intf-2,outside) 192.168.0.46 10.10.0.46 netmask 255.255.255.255 static (intf-2,outside) 192.168.0.47 ...
What are the trunk modes on 3750 and 6509? Desirable? Trunk? Try setting them both to Trunk so they don't have to negotiate the trunking and will always be trunks. Also put a sniffer on the switch, it won't bring down the network, just span the traff...
Konigl, thanks for the info. I didn't know about the diameter parameters - I saw the configuration option but didn't pay any attention to it. The bottom link is down because there is a human intervention - I've turned on the bottom switch last. All t...
