Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 4 switches connected and we had issues with users connecting from the furthest switch. After investigation, I found that there were huge numbers of Input errors on one switch. I swapped the fibre cable and this improved performance but the I...
We have installed a Cisco 2950 switch onto an existing network. The problem we have is that if we set the uplink port to 100MbFD the performance is impacted. This is not the first switch we have connected on this network but is the first one to cau...
After Auto negotiation it reports that the link is auto negotiating at 100MbFD. The 2 switches are about 10 metres apart linked by a crossover cable. This cable was previously used in a Cisco 2924M without any problems.
The other end is connected to a Cisco 3548xl. This was configured to 100MbFD as well. I checked that both ends were set to 100MbFD before installing the switch. It was only after I changed both ends to Auto that the problem was fixed.
