Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi volks, did someone used the 2 PoE-Ports at the Firepower 1010 with FTD 6.6 and FDM? I tryed to connect an AP1815I to Eth1/7. The AP gets stuck in a reboot cycle because he didnt get enough power via PoE (blinking amber-red-green then turning off)....
can u do:sh run tacacs+there should be something like this in the output:ip tacacs source-interface mgmt0 (this forces to use mgmt0-interface to communicate with the tacacs+-server)do you have a mgmt0 configured on each vdc, or just on admin vdc?try ...
The mentioned Bug is something similar, but different.You can instead of autosense PoE-power configure it manually/static.Like this on switches:power inline auto max 15400power inline static max 15400Didnt explain why FPR-1010 missclassify AP as Clas...
Eth1/7 is a switchport and is not on shutdown. AP doesn't show logs. He kinda dies immediately after booting into AP-OS. No relevant Logs got output on Console.The AP LED is doing this:Cycling through Red, Green, Amber and off.● General warning; ins...
Hi diogo,
sry for the late response, been busy at work.
As u mentioned by yourself u can't use FTD with FDM on Site B because it doesnt support PPPoE. So install an FMC in Site B.
The real problem is, that u have to configure a Site To Site VPN...
