Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two routers in HSRP and I would like to create a vpn with a cisco pix. Can i configure the virtual ip address set with HSRP like peer for the pix?Take care.
When I try to launch the mananged daemon on the IDS sensor with 2.5(1)S2 with nrexec or nrset I have this error:Error timeout waiting for response.Why?What means?
I would to connect two pix 520 in a failover configuration.When I ignite the secondary, both secondary's and primary's configuration was resetted. The cable's primary end was inserted in the primary.I premise to have modernized the version of the sec...
The pix's status is inactive. I have opened the errors.managed file and there are the following messages:11/14/2001 17:43:24UTC E Net Device offline at address [192.168.109.1] State [Connecting] SubState [Initial], resetting now.11/14/2001 17:44:04UT...
I also have configured a router like blocking devices and with it the shunning is functioning proprerly..I try to see with the snoop command what happen really with the pix.Thanks care.
Both pix is running the same software version..I configured the primary and then put on the secondary..When I put on the secondary primary's and secondary's configuration wsa erased.I don't understand why.
