Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,
Hoping someone can advise if they see similar in their setup (or not), and if it is a known feature of the Anyconnect client on windows.
Setup is Windows10 clients running Anyconnect v4.6 (though seen on previous version), connecting to an A...
All,
I have a pair of 3750 L3 switches which we use as our internet edge switches running the below code:
sho verCisco IOS Software, C3750 Software (C3750-IPSERVICESK9-M), Version 15.0(2)SE7, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisc...
All,
I have users connecting to an ASA using the anyconnect client, with a profile that is set to reconnect automatically. The profile is set to force all DNS lookups to go the DNS servers set on the VPN connection.
On occasions following an automa...
All, I am trying to configure dynamic access policies on a ASA 5050 running 9.4.1., using split tunnelling. While I can see the acl being applied is being applied as I am using split tunnelling what I am looking to achieve is also the same acl being...
All, We have multiple different internal windows AD domains within our network, that currently do not replicate their DNS zones between them. Is there anyway with an ASA/anyconnect VPN to create a configuration so the ASA inspects the DNS lookups f...
All DNS requests are set to be tunneled (split-tunnel-all-dns enable) but we are at the maximum on the number of DNS names (well its character length I know limitation) but 11 suffix plus the default one (so 12 in total)
Looking at a packet capture I stand corrected and it does appear nslookup still appends the DNS search suffix to the lookup unless you put a trailing " . " on the name -- it appears it is our long search suffix which is causing the issue after all
For anyone that does come across this post looking for the solution unfortunately it appears that cisco have not addressed this and has been around since 2007 ish. Seems like a fundamental flaw in dap (especially as it them appears to always select t...
While I agree there are a lot of options out there (I have looked) I was asking for recommendations. What I really am looking for it ones that are able to present results on the IP ranges in the VPN config. what I need is a tool that can identify mat...
You cannot specify a range only a single port. The way it works is that you point the remote desktop app to the local ip & port (i.e. 127.0.0.1 1028) which the java then redirect to the specified remote IP and port.
