Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all. We're experiencing difficulty allowing traffic from our outside web server's public IP to our internal SQL server on a specific port, on our 10.10.10.1 private network. We have web services for our customers to use that interface through IIS...
Hey all, I've been stumped on this issue for a while now. We implemented a VPN with our Cisco 1941 router with AnyConnect, but the speeds are far from functional: 350kbps to 1.7mbps. Sometimes the connection just dips out and a re-connect is needed. ...
Hello all. We currently deploy two Cisco 1941 routers in our environment. Both routers have separate public and private IP addresses on their respective interfaces. We currently have R1 with an IP of 10.0.0.1 on our 10.0.0.0 network, deployed with An...
Hmm, yeah. That doesn't seem to make a difference... We've even tried a replacement unit and the results are the same... Could it be our SG500X-48p switch that we connect to to go out to the router? I'm at a complete loss as to why this is happening.
@georg See, we originally had that in our configuration but then clients who connected could not access our network's resources, only other machines inside the VPN pool. I was told to set the pool to something outside of the subnet because it would c...
