About shahrun1

shahrun1 · 01-26-2003

Hi guys,trying to find out how to activate Temperature Alarm onmy Cisco Catalyst 4006 using Sup 3 engine. Would liketo configure certain threshold temperature for auto shutdownto avoid module hardware damage because of inconsistenttemperature. I did ...

shahrun1 · 10-13-2002

I have configured my Cisco 1720 Router with a primary Serial interface and a dialer profile tied to a BRI as a backup interface. I am using both the backup load and backup delay commands on the primary Serial interface, to trigger the bri in event of...

shahrun1 · 09-03-2002

My organization is planning to deploy campus IP routing end to end, all the way to the Edge Switches, using Catalyst 3550 EMI series switches. Is it possible for us to activate dispersed VLANS using VTP across active IP routing interfaces?If so, can ...

shahrun1 · 10-16-2002

hey mario,that's right, no such command on a sub interface and there should'nt be any with more recent versions...anyways..as ulrich advised, my problem was withmy loopback network route. but thanx all the same!

shahrun1 · 10-16-2002

Hi ulrich,thanx, for the advice, u were right about the ospf hello packets. I added in the loopback networks and the backup interface kicked off instantly. However, I am only seeing output traffic thru the backup interface, as most of the input traff...

shahrun1 · 10-16-2002

hi mario,actually i tried the backup interface on the serial interface, and fail-over backupkicked in, because it is tracking the line protocol(so even though the serial is up, the backup will trigger because line protocol is down). So, I have no pro...

shahrun1 · 10-15-2002

thankx for the input ulrich, tried ur sample config but was still unsuccessful, the backup interface will trigger only if the primary interface fails , but never when traffic exceeds the maximum load specified, the following is my router config. I ev...

shahrun1 · 10-15-2002

thankx for the input guys,tried ur sample config but was still unsuccessful, the backup interface will trigger only if the primary interface fails , but never when traffic exceeds the maximum load specified, the following is my router config. I even ...

Member Since	‎08-20-2002 08:12 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	9
Total Helpful Votes Received	1

User Statistics

User Activity

Catalyst 4006 Temperature Alarm

Backup Interface Cannot Trigger

Layer 3 Campus Solution

Re: Backup Interface Cannot Trigger

Re: Backup Interface Cannot Trigger

Re: Backup Interface Cannot Trigger

Re: Backup Interface Cannot Trigger

Re: Backup Interface Cannot Trigger