Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I'm doing a college project about redundancy with the following topology. Frame Relay acts as backup connection between routers, and it's on standby mode. Between Routers R2 and R1 there's a HSRP working. My question is, Frame Relay is s...
Hi everyone! I'm a college student and new to Cisco firewalls. This is my first project using ASA5520 and I'm having some issues. The firewall part is pretty basic but I'm not being able to accomplish the task. On my OUTSIDE zone I have a network usi...
Thanks for helping Paul. I'm implementing OSPF lately for the routes. FR must be used only as a backup connection. There's no direct connection between R1 and R2, they are working as a HSRP group using the switches. So when I remove the direct link b...
Hi Paul, thanks for replying. My question was not clear sorry, redundancy between R1 and R2 is working normally with HSPR. The issue comes when I turn off R1, and try to reach R3 network, as the router R2 is checking for F0/0 which still connected. T...
Hi, thank you very much for helping. It's working now, except for R2 network which is on the other side of the Tunnel0. From the Firewall I can traceroute to the Router and PC but I can't connect on my FTP Server from PC. Is any other way of setting ...
Hi Flavio, thanks for replying.It didn't work. I did a test using the same configuration on the firewall but with only one PC as outside network, and it worked perfectly. Any other suggestion? I'll try to erase and do all the configuration again. Tha...
