Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When using EAP-TLS to authenticate clients, is it possible to use integration with active directory?If yes, how is it possible if no password is required? Thanks.
I've read that with the ACS 3.1 the only eap-type supported with PEAP is GTC.Why it is not possible to use EAP-MD5 or EAP-TLS with PEAP? These EAP-type were already supported in ACS 3.0...Thanks for your time.
ACS 3.1 introduces PEAP support:PEAP support—PEAP provides a new, secure, client-server authentication method for wireless networks. PEAP also provides new support for one-time token authentication, password change/aging and powerful extensibility of...
I've read this passage on Cisco web site:To use PEAP authentication, you must install the PEAP supplicant during ACU installation or Service Pack 1 for Windows XP. This Service Pack includes Microsoft's PEAP supplicant, which supports a Windows usern...
I'd like to configure my AP350 via SNMP. In particular I need to change the accepted authentication methods (open, shared or network eap). Does anyone know which are the MIBs to use? Thanks in advance for your time.
Sorry, probably I wasn't clear.My question is: why can't I use EAP-MD5 INSIDE PEAP?By "inside" I mean in the second phase, after the server authentication.I've understood that PEAP is composed by two phases:1-server authentication (by certificate)2-a...
Ok for the first step. But I can't understand why isn't possibile to use EAP-MD5 in the second step.If EAP-MD5 was already supported by ACS 3.0 why it doesn't appear as an EAP-type for PEAP?Are there any limitations on the EAP-Type I use in the secon...
