Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have problem when we use sticky-mask 255.255.255.0. We saw that the css send request from one host to different servers.we use:CSS 11150SW Version: 5.03 Build 15Does anybody know if this is a bug? Did someone had similar experience ?
Hi does anybody know a list or page with debug and show commands to troubleshoot the css. For examlpe for keepalive packets which returns to the css. Or to look how big is the sticky table an so on...Best RegardsAndrea Benanti
Hi We implemented about 50 contents rule on our css all of them are productive. each time when we put a new application we make several performance-test with up to 500 user. We start always only with one server after that we enable the second server....
I upgrade the C3548-XL with the IOS 120-5.WC3b. The Router doesn’t know the Fast Ethernet anymore. Although it knows the Giagabit Ethernet! The bizarre thing about this is if I make a show version it shows me the “48 FastEthernet/IEEE 802.3 interface...
I use the "HTTP Get" as Keepalive for some services on the CSSWhere can I find a description for "Keepalive Errors" ?I have the following state on my CSS:Keepalive Error: General failureThanks Andrea
Hi I implemented the css on peoplesoft portal server. it works pretty fine. the only thing you should have en eye on is on the stickyness. we used "sticky source ip". we saw that if we used sticky by netmask for example class C network, it did not wo...
Hi MilanMany thanks for your help.That with the config was a good think. But even that didn' t bring the result which I hoped. I'm going to send the switch to cisco.CiaoAndrea
Hi MilanI did not miss any step.Here the Output:Show Post:Switch#sh postC3500XL POST FAILURE: Ethernet Controller Test: FailedC3500XL POST FAILURE: MII Test: Failed----------------------------------------------------------------------------Show Versi...
hi milanthe startup-config shows the fastethernet port .with the sh flash conmmand it shows the right ios version but not a ...diag.... file. do you know what I mean with the ...diag...sh flash: I have :c3500xl-c3h2s-mz.120-5.WC3b.binand on another s...
Do you know if there is any explanation why this is not possible?We have the following situation. Our customer and we do not wont to route foreigner ip- address.So thought to make NAT in both ways on one router. In that case we have to implement NAT ...
