Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have several locations using PIX 500 series firewalls with OS 6.3(4) used exclusively for LAN to LAN VPN connectivity. Our VPN topology is fully meshed between all locations. Our Wintel Systems Engineer is requesting bandwidth usage monitoring usi...
We have a location that has a new Internet Circuit installed and a new PIX 515E. The site had pre-existing HP PRocurve 8000M switches installed without VLAN setup, Spanning Tree was setup. The PIX firewall is utilizing 3 ethernet ports (Inside, Outsi...
Thanks for answering that! We have the same needs as well. Would you happen to have a couple sample configs for each end? I know how to configure VPN on PIX firewalls but have never done so on a router.If you don't have any samples, I understand. Tha...
Would this allow hosts on each spoke to communicate with hosts on another spoke? i.e. Site B is the hub site, Sites A and C are spokes off Site B. Would a host on Site A be able to communicate with a host in Site C? Hope I asked this as clearly as po...
Basically, anything that is connected to just the hub can access anything on the Frame / WAN and the Internet. Any device connected on the Procurve switches cannot access anything beyond the firewall. I am actually flying to this site with this probl...
