Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After an upgrade from FTD 7.4.2.1-30 to 7.4.2.2-28 a Site to Site VPN stopped working.This is a packet trace, external 194.13.185.2 , Internal 192.168.20.23It is strange, because all phases have result "ALLOW".Except for the final punch line: Flow...
LDAP integration works, but!!! My FMC operates on VMWare in a management network.I have an inside network with windows domain controllers.Hence the FMC is not able to connect with the domain controllers.This gives a lot of pain to specify the AD Real...
I get the following error in vFMC 6.5.0.1 on a ASA5508-FTD 6.4.0.4 (Suggested software Cisco). Critical Modules:1,Normal Modules:14,Disabled Modules:22ModuleThreat Data Updates on Devices: Cisco Cloud Configuration - Failure. URL Category and Reputat...
We restored our virtual FMC on new/faster hardware, and changed the IP address. Now I want to migrate the ASA devices with sfr one-by-one from the current FMC to the new FMC. Is there a way in expert mode to change the FMC ip-address in sfr without ...
I added a few URL's to the Global-Blacklist-for-URL in FMC.Now I get too many connection events with reason "URL Block" Is there a setting turning off this type of event?
I have the same problem but it is caused by VPN Remote Access configuration.With VPN Remote Access: 94% avg data plane memory Without VPN Remote Access: 76% avg data plane memoryThe default Health Policy warns at 90%.
I started a TAC.The solution was, change the NAT rule:(1) Change Destination Interface to Any (was Outside-interface)(2) Add route-lookup (Strong recommendation from new FMC 7.4.2.2-28)Deploy, and of course a reload of the FTD.
