Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I have config VLAN in FWSM Routed mode.Now i have to prepare auto redundant set up for this with ASA 5540.But my problem is that when primary connection in FWSM fails VLAN which is config is never goes down ,so route is not flush from FWSM r...
Dear all,We have 6500 Switch which include IDS module.We are facing some different problem while accessing IDS Module. We can able to ping module but when we try to telnet which logout session before we can get in IDSM prompt.Is any one facing same p...
Dear All,Now i have 6509 Cisco switch which is having FWSM & ISDM in one box only.My FWSM is working in ROUTED MODE , while MSFC is works as layer 2 module where all customer routers physical interface terminates.1) MSFC Configuration :- firewall mu...
Dear All,In my network set up we have to take new OC-3 connection on our backbone router(3800) for customer's backhaul connectivity.Our Service provider will give us ATM connectivity.Which will terminate in OC-3 port of router.I have some doubts abou...
Dear all,I am facing strange problem with 6500 IDS module.Management port of IDSM is up and Data port 2 Operational Mode: down.When i check traffic on this port it is one way only.I can able to ping IDSM management IP but when i try to telnet it give...
Thanks for reply,Your solution is use when i am using routing protocol but i m not using any routing protocol.I want it through static routing .Thanks SAM
Thanks hritter,Actually my service provider will give us ATM PVC which will terminate on our Router (3845) after that we give different Serial connection to different customer.That means ATM pvc will from Provider switch till our router ( 3800).Aft...
Thanks for your reply,Actually we did not make any changes in configuration.This is working configuration.We can able to ping IDS IP , but when try to telnet i got banner of IDS but does not allow me to give any commands.I am little bit confused abou...
Dear All,Thanks for ur replies but this backup interface will also not solve my probs as I have LL on Router-A and Vsat on ROuter-B . How we can achieve Load balance in this case 1) HO ----LL --- Router A ----Router B ---Vsat--- HO When LL load ...
