Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am working on ISE 2.3 patch 3, I am trying to write an authorization profile like below, to re-direct Guest users to self-register portal after an hour of access using hotspot portal. But AUP greater than 1 hour doesn’t seem to work. Can you...
Hi,
My Cisco ISE primary monitoring node which is 3495 hardware appliance running Cisco ISE 2.3 patch 3. it's disk repository says 100% used(in show disk output). Disk repository as in is it the local disk that is full? How do i lookup what is taki...
Hi,
I am using hotspot portal for guest access with just AUP accept, i have my guest endpoint identity group set to purge everyday at 1:00 AM (elapsed days greater than 1) my aim to get the guests just one day access and to be purge after a day whi...
Hi,
I am planning on promoting Cisco ISE 2.3 Secondary admin node to primary, it is an 3495 appliance, my question is do i have to do a manual sync up before i promote it and my radius traffic which is currently being served by 4 PSN's will that be...
Hi all,
I am planning to upgrade cisco ise from 2.0 to 2.3 , i ran URT Tool on Secondary admin node, its estimated time of upgrade was around 42 hours, i purged MNT data and tried running URT tool again to see the estimated time, but it says applic...
Hi Mohammed,
I am using 2.3 as well, so what you meant to say is, i should write a condition which says the endpoints in my endpoint guest identity group whose AUP hours are greater than 24 hours should get a terminate COA?
RJI,My primary PAN is healthy nothing wrong with it and i want to promote my secondary PAN because it was primary prior to my ISE upgrade. Will both the PAN's restart after i login into the secondary pan and promote it?if so will they restart at the ...
Hey, my upgrade failed in the very same step, i raised a TAC case and its been identified as the software bug and TAC gave me a patch to install in all the nodes and then my upgrade was success. I would suggest you to work with TAC.
