Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Per my original post, I decided to factory reset my ASA 5510 running version 8.2(5) and ran into the exact same issue - no DNS translation for clients. The firewall itself can hit stuff fun, but the devices themselves. Does anyone know of a ...
Good Morning Cisco Forums,
Long time lurker, first time poster. It's been a few years since I've gotten my hands into an ASA, and I recently got one to mess around with in a home lab situation. I've got it (Mostly) configured, but I've run into an ...
I was using external DNS for all clients. Both manually configured, and from DHCP.
I ran the command you recommended. No change. The Firewall can ping by ip and DNS name. Clients can ping by IP, but not by DNS name.
I have no firmware to update to, so I am stuck working with what I have. I found a different forum post explaining a basic setup, so today I am going to flush it back to factory defaults, and try a base config and see where it gets me. unless you, or...
The syntax above, nat (inside,outside), doesn't work for this ASA either... unless I'm doing something wrong.
logged in
enable
config t
etc..
How would I remove what you're saying?
