Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have one switch in place (Cisco Catalyst 3960-CX 16 port.) and I want to connect another switch to it via a trunk port. The second switch is an older catalyst 3960 24 port.
My Network uses VTP, and the trunk link has the native vlan set as 20.
...
Thanks for the help mate, I managed to figure out what SOME of the issues were:
1) Once VTP is enabled the catalyst switch needs you to move the vtp to server mode before making new vlans and then entering apply in vlan database. Best to move to a ...
I have created vlan 20 using the vlan database and configured it in interface mode.
It does NOT show up when you do "show vlan" .
#vlan database
#(database) vlan 20
(config)# int vlan 20
(config)# ip address dhcp
I also think this could be th...
