Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently my ASA 5505 is setup using our WAN address from ISP for outside interface and vpn. Our ISP is changing the WAN block but not the what they call the Lan block.. It is outward facing not a private ip space. My question is how to I use the IP'...
I have a Cisco ASA 5505 with security plus license. I have been tasked with setting up a sg-300 in layer 3 mode to handle the inter-vlan routing instead of the asa. I'm new to cisco, I cut my teeth on Brocade and foundry and the ASA is a beast on its...
We currently have 1 wan IP and 8 lan side IPs from AT&T. Current setup is using the WAN IP from AT&T which is in 12.247.7x.xxx. This what the outside interface is setup on and also the vpn. We have 8 lan side from AT&T 12.202.13x.xxx /28. My questio...
When my vpn session is active I am showing that the tunnel is inactive on the client. I'm using cisco vpn client. VPN works and I can ping and remote desktop into host. Should this be a concern?
Yes the sg300 is like a IOS-Lite... not sure if that is real but it is a stripped down version of what would be on a catalyst switch or IOS based router. Yes now the vpn is working like intended. Next question is for the dmz should I just create dmz ...
Yes all devices can reach the internet and each other. Inter-vlan is working by the SVI for each vlan. I previously have the 192.168.1.0 network as a svi connection to the asa from the 300. I since moved it to a routed port. It is using 192.168.11.0 ...
