Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,For this scenario, I would suggest using the USB boot / disaster recovery method directly to IOS XR 25.2.2. This should save you a lot of time compared to performing multiple intermediate upgrades.Since the router is coming from storage and you ar...
Hello kauemoncao200,
Can you share the configuration?I've seen this before if ISIS is configured with single-topology, but you don't enable ipv6 address family on the interface.This will trigger this issue.
Hello Gerardo, You can find the RSP LED Definitions on the link below.It provides a detailed description of the LED alarms on the RSPs and other modules
https://www.cisco.com/c/en/us/td/docs/iosxr/asr9000/hardware-install/overview-reference/b-asr9k-o...
Hello Jack,
From sysadmin mode, you can use the following command to copy a file to the XR VM:
sysadmin-vm:0_RP0# copy file_source_location file_destination_location location 0/RP0/CPU0/VM1
Example:
sysadmin-vm:0_RP0# copy harddisk:/test-file.txt har...
Hello Najeh,
The following link will take you to NCS5508 IOS XR Software download page for 7.5.2One of the files listed is the NCS5500-docs-7.5.2.tar, which contains the IOS-XR System Upgrade Procedure for 7.5.2.
This document provides information ab...
