About hauret

hauret · 03-04-2023

I have a pair of Nexus 5596 switches that are configured to be VPC peers. One of the switches is “dead” and I cannot get the active VPC member to restore the configured VPCs to resume operations.The current config of the live switch (VPC peer) is:VP...

hauret · 03-04-2023

Removing the vPC does solve the current issue at hand. Awesome suggestion. I was completely overlooking the easy answer there. Thank you MHM.

hauret · 03-04-2023

Thank you MHM. I do have the surviving switch NSK-1 configured as suggested. I don’t have an NSK at current to modify setting since that switch did not survive a power event. Hopefully there is a way to get the surviving switch to make the configure...

hauret · 03-04-2023

Thanks for the guide above, unfortunately, I don’t have a peer switch that I can use for the peer link. For the meantime, all I have is the single switch so I am trying to get it to make active the configured VPC. We had a power event that downed t...

hauret · 03-04-2023

Peer keepalive is in global. However, to confirm, I changed it to mgmt, then in viewing the show VPC brief the keep-alive status shows “Suspended (Unusable VRF)”.

hauret · 03-04-2023

I’ve placed that command but the VPC are not recovering. Is there a subordinate command that is necessary to run after adding the vrf default?

Member Since	‎01-30-2018 08:59 AM
Date Last Visited	‎03-11-2023 05:03 PM
Posts	6

User Statistics

User Activity

VPCs Peer is Dead

Re: VPCs Peer is Dead

Re: VPCs Peer is Dead

Re: VPCs Peer is Dead

Re: VPCs Peer is Dead

Re: VPCs Peer is Dead