Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am able to ssh inside IP address from a seaprate SecureCRT session. But when I ssh from a Cisco isr4331 router i am getting following error [Connection to IPADDRESS aborted: error status 0]. I did confirm Data Interface is allowing Inside interface...
The Airplay disconnects because of "Allow all traffic over tunnel" or your home network is in your VPN network.I was able to fix the issue. Follow these steps1. Find out your iPad IP address (example: 10.0.0.150)2. If you have access to the Home mode...
Can you share the ASA ssh config ("show run ssh")?MC-AR-FTD# sh run sshssh 0.0.0.0 0.0.0.0 insidessh 0.0.0.0 0.0.0.0 outside-sec Is the source IP of the session from the ISR in the same allowed subnet as the source of your SecureCRT session?That is c...
So router's g0/0 and FTD's INSIDE interface are in same subnet. I am able to ssh with inside ip address when i create a new session on SecureCRT. I think there is something with cipher on the router or FTD.