Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I have setup etherchannel trunk between 2 2960 switches, the PC's in 1st switch connected directly to the router receives DHCP addresses that are configured in the router.
The PC's on the 2nd switch forming an etherchannel trunk between the...
Hi Georg,
Thanks very much for your assistance. It worked like magic.
In summary when a layer 3 device has Vlan configurations, no need to configure vlan interfaces on the switch and if 2 switches are trunking, one has to be a server and the other cl...
Hi Georg,
Vlan 30 and Vlan 40 interfacs has been deleted on SW2 as required.
SW1 vtp Status output
SW1#sh vtp status
VTP Version : 2
Configuration Revision : 4
Maximum VLANs supported locally : 255
Number of existing VLANs : 7
VTP Operating Mode ...
Dear Support, please find the output of sh run on SW2
SW2#sh run
Building configuration...
Current configuration : 2571 bytes
!
version 12.2
no service timestamps log datetime msec
no service timestamps debug datetime msec
no service password-encry...
SW1 gig0/1 connects to R1 gig0/1 interface
SW1 output of sh int trunk
SW1#sh interfaces trunk
Port Mode Encapsulation Status Native vlan
Po1 on 802.1q trunking 1
Gig0/1 on 802.1q trunking 1
Port Vlans allowed on trunk
Po1 1-1005
Gig0/1 1-1005
P...
Here Below is the R1 Config:
R1#sh run
Building configuration...
Current configuration : 1962 bytes
!
version 15.1
no service timestamps log datetime msec
no service timestamps debug datetime msec
no service password-encryption
!
hostname LAN228
!
...
