this is the scenario where i want to configure HSRP between both the nexus
1) both the ips 172.15.15.252 & 172.15.15.253 are configured on nexus as interface vlan 15 and 172.15.15.1 is virtual ip for hsrp.
2) both the nexus is connected via pee...
Hii,
But as there is only one link from each hp switch coming to nexus so there is no much sense of using port channel unless there is more than one link between same source and destination.
but one key point need to be take care is that HP switc...
hiii,
But as there is only one link from each hp switch coming to nexus so there is no much sense of using port-channel unless there is more than one line although i can check with the configuration as mentioned and to make it sure that no any port...
Hi Reza,
This is what i have found to do and implementing the same, and one another thing which i would like to know that as HP switch is connected via both the nexus and all the links are trunk link so here stp will be taking place to avoid the L2 ...
Hi Guiseppe,
but the same ports are being used for L2 functionality and when i am executing the command - no switchport so i am getting error message - requested config change not allowed and at the same time there are also another SFP ports on whi...