Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a simple DLSw config that doesn't seem to be working. The peers are up, but when the "debug source bridge" command is issued the following appears on the screen...Error only happens on R2Oct 18 09:58:22 EDT: SRB0: explorer enqueued (srn 116 b...
Just want to find out what the default sticky bit timeout value is. I cannot seem to find it...I know how to change from the default...but what exactly is the default?Thanks,Brett
I read the post on DLSW ER, now what if I have a router that is trunked to a switch and have 3 or more VLAN's on the local network. Will the standard config automatically "collect" the mac's from each address?Does the "dlsw transparent redundancy-en...
I found that there really is no timeout value...Q. What is the default time an entry is kept in a sticky table?A. There is no default time. The sticky table is kept on a FIFO basis (32 K of entries), or until the CSS is rebooted.If this is the case, ...
