Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Day. i am having an issue with nating from a local devices to devices on the other side of the internet. In the NAT table it show that the address is being translated but local all it says that the destination host is unreachable.
the config...
i have been having an issue with a lab i have been doing in packet tracer. i have a few networks configured connecting to their receptive sub-interfaces on router one. all the networks can communicate among each other as their networks are being adve...
@Dennis Mink wrote:
Johns point is still valid, you are now doing source NAT to hide your 192.168.10.x addresses, so far so good, but you are still trying to connect to the unnated 192.168.20.x on the far end, so your :internet router in the middle h...
@Jon Marshall wrote:
You are only doing NAT on the source IPs and the ISP router does not have routes for either 192.168.10.x or 192.168.20.x.
So when the packet arrives at the ISP router it cannot forward it because it does not know where to ...
let me do that on the fly. i was thinking about that. the reason i didn't do it was because i was thinking that i should at the very least ping the 145.207.45.1. i have done something similar to this when i was learning vpn but no sub-interfaces just...
lol my bad i am multi-tasking
@Georg Pauwen wrote:
Hello,
the idea was to post the .pkt (renamed as .jpg) so we can open the project and check what you are missing...
