Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Teamhope everybody fine in current covid19 situation. Recently we buy the wireless controller C9800-40-K9 and C9120AXI-E we had cisco prime version 3.5 for monitoring wireless controller, access point and switch. we recently upgrade cisco prime...
Hello Team, i am trying to deploy the two C9800-40-K9 controller in the network1- Before connecting the both controller to the networki had given one ip adress 10.91.225.80 ip to the Gi0 of WLC1 and connected the cable between SP port and laptop wit...
@Rasika Nayanajith Many thanks It is working now we have used the local user authentication for netconf configuration as mention in the guide as mention in the guideCaution: If aaa new-model is enabled on Cat9800, then you will also need to configure...
Hello marce1000 and Scott Fella thanks for all your timethere is no specific details for this access point model in device support list in 3.7 DP2 Hello Rasika,Thank you ,as per the document all the configuration is already in place with snmpv3,wlc ...
Thank you so much for all your time and solution and sorry for the late replyLast week we disable https access and only permitted http access to get the browser,we got the http access of primary WLC and showing HA is not working properly so we break ...
