Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there no way to disable ICMP redirects on the SG300-10?
With the wirespeed routing when running in Layer 3 mode, the SG300-10 sends a ICMP redirect message if the next hop is on the same broadcast domain as the host. As I have the network config...
But you are using the 10.17 network as that is the IP address of the FTP server in "ip dhcp database ftp://...@10.17.1.3/ftp_dir/router5"?If the computers are actually getting addresses in 10.18 networks, are the computers actually recieving 10.18.1....
Just to clarify with some questions. Your configuration lists the DHCP pools as 10.18 networks, but you talk about 10.17 networks in your question. Are these correct? Does the switch have another interface not mentioned in that config that is on the ...
If you are handing out 10.17 addresses as per the mapping database, the switch has no DHCP pool default route configuration for the static maps under ip dhcp pool ab .
You say: "Yes i did a tracert but it seems to be going via it's serial interface of the ISP... "This means client traffic is being sent to the ISP router in order to reach the other VLANs.Make sure that the clients are not doing any split tunneling w...
Can you do a traceroute from a device on the VPN to one of the VLANs to see what path it is trying to take, and make sure that each device in the traceroute has the proper next hop configured to get it to the other VLANs, and has the proper next hop ...
