Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there, I am going to attach one Cisco 1760 router at the end of DSL line. My service provider has given us one static IP address with 255.255.255.255 subnet mask and no gateway address. I am going to run IPSec VPN between this router and our ce...
Hello, I have a PIX 525 with 5 interfaces (Outside<0>, Server DMZ<40>, RAS DMZ<50>, VPN DMZ<60>, and Inside<100>). I have a couple of site-to-site VPN connection in the VPN DMZ and some remote access users on the RAS DMZ. Users from RAS DMZ and VPN D...
Thank you for your reply. I think I can manage the VPN tunnel between those two routes(Center and this router) once I resolved my concern on the IP address with 255.255.255.255 subnet mask. I still have concern with this IP address. My ISP has given ...
Hello Raul,Are you running cisco VPN client 4.0.2 on Windows XP with SP2?I also recently encounter some issue with this cisco VPN client software.We are using Cisco VPN client 4.0.2 on Windows XP with SP2. Before we deploy SP2 on the XP, it was ok. B...
Thank you dave for your reply.I agree that nat exemption[ nat(interface) 0 access-list acl ] does not create any xlate and it will allow traffic in any direction. However I am so curious on which interface should I apply this nat exemption? Let's say...
If you haven't have any access-list applied to the dmz interface, you are right that all traffic from your dmz to the outside should be allowed by implicit rule. However, once you have a access-list applied, you need to allow explicitly all traffic y...