Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
Trying to get this 4G router up and running but its not going well. I used CCP Exress to set it up and it works for the most part but only on EDGE(1X) and 3G at extremely slow speeds. It never negotiates its way to 4G and if manually set...
Hello, just wanted to give you an update since you've been helping me. currently this project is going on hold for a while. After trying your last tips ive pulled the Modem card out of the cisco and have since hooked it up to my laptop directly with ...
yep, by default it comes on auto mode. im not playing with it using "conf > controller cell 0" im just running the commands straight from the enabled CLI. and ive attached the config exactly as pulled of the unit with tftp to my laptop. (made .txt fo...
You can issue a command at the CLI for "cell 0 lte tech auto" or "cell 0 lte tech lte"that sets the radio communication. if i leave mine it auto its borderline useless it wont talk its way up to anything higher that EDGE 1X or barely 3G. why i think ...
Alright, got that copied in, I'm now able to ping from the router to 8.8.8.8 on auto mode (it was in 1X mode when i did but it pinged and got an ip address so it at least works. at this point with your config i think the config side is good but I thi...