Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,i have some doubts regarding which parameter must be checked to permit an etherchannel creation.I found the following info on a Cisco pdf but i remember that there are some other parameters like duplex mode or STP settings that must be...
Timestamp ping option
Hello everyone,
i was wondering if there is a method to have a verbose output of the ping with the timestamp related.
As you can see, i mean an output like this:
14:35:43 2018-4-24 DST Reply from 8.8.8.8: bytes=...
Hello everyone,
i was wondering if there is a method to have a verbose output of the ping with the timestamp related.
As you can see, i mean an output like this:
14:35:43 2018-4-24 DST Reply from 8.8.8.8: bytes=56 Sequence=1 ttl=54 time=20 ms1...
Hi everyone,
i've a questione for you:
if i send a packet with the don't fragment flag in the ip header and the MTU is not as high as the size of the packet (e.g. packet size 2900 , MTU 1600), is there a counter that i can see increasing? is ther...
Hello Georg, thank you. You are right, i'm searching info about standard iOS.Unfortunately i have a catalyst 2950 that does not support this command. If you have the full list of compatibility requirements it will be wonderful.Thank you!! Lorenzo
I need to keep a ping open for hours and need to know at what specific minute and seconds it dropped packets, whether it drops By the way thank youLorenzo
Hello,
i tried the way you told:
ping
Protocol [ip]:
Target IP address: 8.8.8.8
Repeat count [5]: 1000
Datagram size [100]: 1400
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface:
Type of service [0...