Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Is there a way for administrators to set a specific ring tone one each line of a Cisco 8861 SIP phone under CUCM 11.5? The admin configurable ringer option on the device configuration page sets the ring tone for all lines, but we need to set...
In case it helps anyone else who finds this thread, I had similar questions about the CAP-RTP-001 and CAP-RTP-002 certificates that expire in 2023.Our CUCM cluster is version 14.0.1.11900-132. We have the CAPF service activated but the cluster is not...
I was able to identify the source of the issue after further troubleshooting and wanted to report back in case it helps someone else.
In our use case, we have analog single-button intercom phones that are connected to a VG310 gateway with an SCCP P...
Thanks for the information Jonathan.
I wasn't aware that D was a legitimate DTMF code. The weird thing about these calls is that they are originating from a SCCP PLAR line on a VG310 voice gateway. The analog endpoint is not programmed to dial any ...
